Prev Previous Post   Next Post Next
Old January 3rd, 2011, 07:51 PM   #1
rockin jester
Rockin Jester Racing
rockin jester's Avatar
Join Date: Jun 2005
Location: Millersport Ohio
Age: 52
Posts: 319
Send a message via Yahoo to rockin jester
Default Crank support question

I am Setting up the srank support shaft and can't get it centered. I am using a dial indicator on the support shaft where the berring would ride. The closest I have been able to get it to center is .010" It is a procharger crank support, 77t cog with ATI hub and ballancer. At first when I bolted the support shaft thru tha cog to the ballancer hub I have a slight wobble with the cog. After taking some measurements the hub snout was coming into contact with the support shaft. After a little machine work I can get it tight now but still can not get it within .010 centered. Anyone else run in to this or have a solution?
rockin jester is offline   Reply With Quote

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -4. The time now is 12:21 AM.

Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.